Connecting Using Usb Cables - Oki C931dn User Manual

Connecting the PC

Connecting Using USB Cables

Connect the device and PC using USB cables.
1
USB cable
2
„ Preparations
Note
3
⿟ USB cables are not enclosed with the device. Prepare
USB cables with USB2.0 specifications, length 2m min. as
necessary.
⿟ If connecting using USB2.0 Hi-Speed mode, use a USB
cable with Hi-Speed USB2.0 specifications.
4
USB cable
„ Connecting USB Cables
Note
⿟ If the printer drivers are not installed on the PC, remove
the USB cable fromthe PC, and first install the printer
drivers. (page 72)
1
Pay attention to the connector
orientation, and connect the square end
of the USB cable to the Printer (
Connect the other, flat end to the PC ( ).
USB port
Note
⿟ Be careful not to insert the USB cable into the LAN
(network) interface connector. Doing so may cause a
printer malfunction.
⿟ Do not insert the USB cable when the PC or device power
supply is ON. Doing so may cause a printer malfunction.
Memo
⿟ Set the device USB baud rate using the control panel
according to the USB port baud rate (speed) mounted
to the PC. For the control panel, see
Appearance" (P.32).
- 64 -
USB interface
connector
USB cable
"Control Panel
).