Connecting The Erm(S) - HP R3000v User Manual

INSTALLATION
12
HP R3000v UPS User Guide

Connecting the ERM(s)

To install the optional ERM(s) for a UPS:
1. On the bottom of the UPS right front bezel, remove the knockout for the ERM cable.
See Figure 10.
NOTE: Use care to protect the control panel and the connected ribbon cable from damage.
2. Remove the front bezel of each ERM. See Figure 11.
To remove the bezel, loosen the two captive screws on the right side of the bezel.
Grasp the sides of the bezel. Slide the bezel to the left and then away from the
cabinet.
ERM Bezel Hook
Bottom ERM Cable Knockout
(underneath bezel)
S 164201731 Rev 1
ERM Cable Knockout
Figure 10 Removing the Knockout
Top ERM Cable Knockout
Figure 11 Removing the ERM Front Bezel