Table of Contents
Advertisement
When you are at the top level, the prompt shows :>, and if you are at the group level, the prompt
displays the group name, e.g. System>.
To be under a certain group, you may enter the group name at top level or add / in front of the group
name then press enter at any level. Examples:
At top level:
>system <enter>
At any level:
system>/ip <enter>
To be at top level, you may enter up at any level. (ex, system>up <enter>).
Note:
All the characters entered in the command line interface are NOT case-sensitive.
7.4 Help Utility
You can get command information by entering ? or help.
Prompt at top level
System
System commands
Console
Console commands
Port
Port commands
MAC
MAC table commands
VLAN
VLAN commands
Aggregation Aggregation/Trunking commands
QoS
QoS commands
Mirror
Mirror commands
IP
IP commands
Prompt at group level (Example: System>? <enter>)
System Configuration [all]
System Restore default [keepip]
System UserName [<name>]
System Password [<password>]
System systemname [<systemname>]
System Reboot
Help after a specific command (Example: System>configuration ?)
Syntax:
System Configuration [all]
Description:
Show System Name, Username, Password, Software Version, Hardware Version
and management MAC address. Optionally show the full configuration
[all]: Show the total switch configuration (default: System configuration
only)
New prompt -> System>
New prompt -> IP>
-28-
Advertisement
Table of Contents
