Replacing The Fuser; Removing The Used Fuser - Dell 3110CN Owner's Manual

Replacing the Fuser

CAUTION:
To prevent electric shock, always turn off the printer and disconnect the power cable from
the grounded outlet before performing maintenance.
CAUTION:
Before performing any of the following procedures, read and follow the "CAUTION: Safety
Instructions" on page 9.
NOTICE:
To protect the drums of the print cartridges against bright light, close the front cover within 5
minutes. If the front cover remains open for more than 5 minutes, print quality may deteriorate.
NOTE:
For information on when to replace fusers, see "Print Cartridge and Printer Life" in User's Guide.
NOTE:
Remove any print jobs from the center output tray, and close the multipurpose feeder cover
before opening the front cover.
Dell fuser are available only through Dell. To order by phone, see "Order Printer Supplies" on
page 2.
Dell recommends Dell fuser for your printer. Dell does not provide warranty coverage for problems
caused by using accessories, parts, or components not supplied by Dell.

Removing the Used Fuser

CAUTION:
To avoid burns, do not replace the fuser immediately after printing, as the fuser gets very
hot during this process.
Turn off the printer and wait for 30 minutes for the fuser to cool down before removal.
1.
Push the side button and open the front cover.
2.
65
Maintenance