Encryption Led, Ultrium 3000 Models Only; Encryption Led, Ultrium 3000 Tape Drives - HP StorageWorks User Manual

LED Sequence
The tape is ejected
immediately and Tape
FLASHES, or Drive FLASHES
on unloading tape.
Drive FLASHES.
Drive, Tape and Ready
FLASH.
Drive and Ready ON with
Tape and Clean OFF.
Alternates repeatedly.

Encryption LED, Ultrium 3000 models only

The encryption LED may be blue or amber, as described in the following table. The state of the other
LEDs depends upon the activity, as described below.
Table 6 Encryption LED, Ultrium 3000 tape drives
Encryption LED (Blue or Amber)
On
Off
Off with Ready flashing green
On (solid blue)
On (solid blue) with Ready flashing
green
Alternate flashing, blue and amber
Cause
The tape cartridge memory
(CM) may be faulty.
The drive mechanism has detec-
ted an error.
There is a firmware download
problem.
The drive has a firmware error.
State
At power on
The drive is idle and there is no encryption key.
The tape drive is reading/writing unencrypted data from another host
or unloading a cartridge.
The drive is idle but the encryption key is loaded. The drive is ready to
read/write encrypted data.
The drive is reading/writing encrypted data.
There is an encryption related error. This is cleared after unload executes
or successful encryption/decryption resumes. See also
troubleshooting" on page 69.
Action required
Write protect the cartridge by sliding the
switch on the tape cartridge, see
protecting cartridges" on page 51. The tape
can be loaded and the data read. Once the
data is recovered, the cartridge must be
discarded.
Load a new cartridge. If the error persists,
power cycle or reset the drive.
If the Drive LED remains on, call for service.
Insert a cartridge to clear the LED sequence.
If the condition persists, call for service.
Power cycle or reset the drive.
Upgrade the firmware. If the condition
persists, call for service.
Ultrium Half-Height SAS Tape Drives
"Write
"Encryption
65