Reference; Firmware Upgrade - Samsung DVD-P390 User Manual

reference

Firmware upgrade

Introduction
Samsung offers software upgrades to improve the
performance of this unit, through the Samsung Internet
Site (www.samsung.com).
Because the new mpeg4 codec continues to appear
more often. What improvements are made depends
on the software upgrade you are using as well as the
software that your DVD-player contained before the
upgrade.
How to make an upgrade disc
Write the downloaded file onto a blank CD-R or CD-
RW disc, using the following settings:
1. You have to download a new file through Download Center
on the Samsung Internet Site (www.samsung.com).
2. Write the file to Disc using CD-RW of your computer.
Note
- File System CD-ROM ISO Level
- Character set ISO 9660
- Finalized, single session
- Write speed low
Upgrade procedure
1. Open the disc tray. Place the disc on the tray. Close the
tray. The Firmware upgrade screen appears.
Firmware upgrade
appears on the display
2. Press the √/® buttons to select Total, then press the
ENTER button.
- In the middle of the writing, the tray will open
automatically. After taking out the disc, please wait for
about 2 minutes.
- If the unit was succesfully updated, the unit will turn off
and on after closing the tray automatically. When the
unit turns on, this screen will display.
3. Press the π/† then press the ENTER button to select the
desired language.
Note
- If the "Select Menu Language" doesn't appear,
please contact the "Samsung Service Center".
- Do not press any button or unplug the power
during upgrade.
- The upgrade procedure may change, refer to
the web site (www.samsung.com).
Firmware upgrade starts
English
Français
Deutsch
Español
Italiano
Nederlands
English _1