Kenwood Rs-232C Data - Tokyo Hy-Power HL-1.5KFX User Manual

9-4 Kenwood RS-232C Band Data
Using the Kenwood band data connection cable (shown below), connect the transceiver (example
TS-950, TS-870) to the HL-1.5KFX as illustrated below.
Initial settings for the transceiver are as follows :
Communication Speed
Stop Bit
( Refer to the Kenwood radio manual for more details).
Turn off the AC POWER to the transceiver and the amplifier. Connect the D-SUB (9 pin) plug to the COM
(D-SUB 9 pin socket) on the rear panel of the Kenwood transceiver. Connect the other D-sub 9 pin plug
to the KENWOOD (D-SUB 9 pin socket) on the rear panel of the amplifier.
Check that the transceiver is in receive mode. Turn on the AC POWER to the transceiver and the
amplifier. Observe that the band indicator (LED) of the amplifier matches that of the transceiver.
Kenw ood R S232C Band D at a Cable
KE NWOOD TRANSCE IVER
AN T
REMOTE
: 9600 (bps)
: 1 bit
D - SUB 9P FEM ALE
COM
DSUB 9P FE MA LE
KE NW OO D RS232C BAN D DATA C AB LE
ANTA
INPUT
SWR/POW ER METE R
TX
HL -1.5KFX REAR VIEW
17
D - SUB 9P M ALE
AN TENNA
ANT
KE NWOOD
DS UB 9P MA LE
SEND
ALC