Connection & Operation - Tokyo Hy-Power HL-1.5KFX User Manual

7. Connection & Operation
This section explains a one-antenna system or two antenna system with basic connections to the
transceiver, where no band data cable is connected. In this case, band setting is made with MANUAL
mode, pushing UP/DOWN keys. Advanced operation using the band data cable is described in Section
9.
*** CAUTION : Under the Manual Band Set operation, always be sure to check if BAND Switch position
matches that of your radio before keying PTT or the CW paddle. Also when you have changed the BAND,
do not make the full power CW ( carrier ) drive but reduced level power to see if the BAND is set
correctly and the amplified RF power comes out properly. Full power CW drive under the BAND Miss-
Set leads to the failure of the valuable final power FET devices. ***
One Antenna System Example
TRANSCE
ANT ALC
Two Antenna System Example
TRANSCE IVER
AC C
SE ND
ANT ALC
TX GN D
IVER
AC C
SE ND
TX G ND
AN T A
INPUT
ANTB
ANTA
INPU T
Antenna
SWR/POW ER METER
TX ANT
HL-1.5KFX REAR
50MHzANTENN
SWR / POWER Πv
TX ANT
HF ANT E NNA
SWR/PO WER MET E R
TX ANT
HL-1 .5KFX REAR
10
SEND
ALC
TO AC200V or 100V PLUG
A
SEN D
ALC
TO AC 200V or 100V PLUG