Connecting The Fm And Am Antennas - Yamaha RX-V657 Owner's Manual

Connecting the FM and AM
antennas
Both FM and AM indoor antennas are included with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
Indoor FM antenna
(included)
AM loop antenna
TUNER
75 UNBAL.
AM
FM
GND ANT
ANT
Ground (GND terminal)
For maximum safety and minimum
interference, connect the antenna
terminal to a good earth ground. A good
earth ground is a metal stake driven into
moist earth.
Connecting the AM loop antenna
1
Set up the AM loop antenna.
2
Press and hold the tab to
insert the AM loop antenna
lead wires into the AM ANT
and GND terminals.
3
Orient the AM loop antenna
for the best reception.
(included)
GND
Notes
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
• A properly installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality, an
outdoor antenna may improve the quality. Consult the nearest
authorized YAMAHA dealer or service center about outdoor
antennas.
Connecting the 75-ohm/300-ohm
antenna adapter (U.K. model only)
1
Open the cover of the
included 75-ohm/300-ohm
antenna adapter.
2
Cut the external sleeve
of the 75-ohm coaxial
cable and prepare it for
connection.
3
Cut the lead wire and
remove it.
4
Insert the cable
wire into the slot,
and clamp it with
pliers.
Insert wire into
slot
5
Snap the cover into place.
CONNECTIONS
11
Unit:
8
mm
6
Lead wire
Clamp
Clamp
21