Troubleshooting - Doyon PIZ3 Manual

A-18
Always cut off the main power before replacing any parts. Take care of the electric wire
supply system when pulling the oven.
Control parts on the front control:
Motor system on the back of the oven:
Questions
The oven does not turn on.
Uneven baking.
The oven does not produce heat.
If the OVERHEAT WARNING light is on,
and you hear the warning buzzer.

TROUBLESHOOTING

BEFORE CALLING FOR SERVICE
ANSWERS TO MOST FREQUENT QUESTIONS
Remove the side panels of the oven and the
proofer by screwing out the screws.
Pull the oven and screw out the panels.
Solutions
Check the breakers on the front panel.
Check the breakers of the building.
Check if the doors are tightly closed.
Make sure that the grills don.t obstruct the air
flow. Do not use foil on the grills.
Verify if the rack inside the oven rotates.
Verify the temperature of the oven by using an
oven thermometer and make sure that it is even
with the thermostat setting.
1. If the oven blowers are on
•
Make sure: the thermostat is adjusted to a
temperature high enough to turn on the pilot
light.
2. If the oven blowers are not on
•
Check the overload relays located in the
control compartment. If anyone of these is
disengaged, call for a qualified technician.
Check if the cooling fan airflow is not obstructed.
Check the cooling fan if it is running. If the
malfunction light goes on, or if the audible
sound, appliance is malfunctioning.
TURN OFF or disconnect appliance from power
supply and have serviced by a electrician.