Advertisement
CONTROL FUNCTIONS
7. SPEAKERS
Connect subwoofers to these tenninals.
8.GND
AQA430SL
f
AQA430WT
GRAY
GREEN/BLACK
WHITEJBLACK~
PURP
LE
WHITE~
PURPLE/BLACK
GRAY/BLACK
GREEN
Connect this tenninal directly to the sheet metal chassis of the
vehicle,
using the
shortest wire necessary to make this connection. Always use wire of the same gauge
or larger than the (+) 12 volt power wire. The chassis connection point should be
scraped free of paint and dirt. Use only quality crimped and/or soldered connectors
at both
ends
of this wire.
Warning: Do not connect this terminal directly to the vehicle battery ground terminal or any otber factory ground
points.
9. Remote Turn On
This
tenninal
turns
on the amplifier when (+) 12 volt is applied to it. Connect it to the
remote turn on lead of the head unit or signal
source.
10.
(+)12 Volt Power
Connect this tenninal through a FUSE or CIRCUIT BREAKER to the positive tenninal of
the vehicle battery or the positive tenninal of an isolated audio system battery.
Warning: Always protect this power wire by installing a fuse or circuit breaker of the appropriate
size within 12 inches of the battery terminal connection.
II. FUSE
These fuses protect the amplifier against internal electrical damage and are meant to
protect the amplifier only. All other power connections should be fused at the source.
AQA430SL
I
AQA430wr : 40A X I
12. LED
Will illuminate GREEN to indicate the amplifier is on and operating
nonnally,
and will
be illuminated RED ifthe amplifier shuts down due to short circuit, DC
offset,
or
overheating detected by on board protection circuitry
7
Advertisement
