Advertisement
TABLE OF CONTENTS
......................................................
............ 3
.........................................................................
4
PANEL LAYOUT ............................................................................... ....
...
5
FUNCTIONS ............................................................
6, 7
SPEAKER
CONNECTION
4 CHANNEL CONFIGURATION
....................
.
8-10
TROUBLE SHOOTING GUIDE ............... ............................................... 11
SPECIFICATION ...................................................................................... 12
WARNING....................................
....................
......................................
13
PLANNING
YOUR SYSTEM
Before beginning the installation, consider the following:
I. Do you plan to add
additional
mobile electronics equipment in the future?
If you plan to expand
your
system by adding other
components
sometime in the
future, ensure adequate space is left and cooling requirements are met.
2. Should you use high or
low
level inputs?
Your Amplifier has been designed to accept Low-Level(Pre-Amp outputs from
your
radio) source
signal.
If
your
radio/source is equipped with Pre-Amp outputs, it is
possible to utilize them to drive the Amplifier and the 2 front
speakers.
Then, use the
built-in power of your radio to drive the 2 rear speakers.
3.
Are
your
components matched?
The RMS power rating of
your speaker(s)
must be equal or greater than the RMS
power rating of your amplifier. Your speaker(s) also must be 2 - 8 Ohms impedance
for
stable
amplifier operation. Impedance information is normally printed on the
speaker
basket or
magnet.
4.
Where will the amplifier be installed?
Consider
both the length of your leads, and routing when determining the mounting
location. It is best to run power and RCA wiring on opposite
sides
of the vehicle to
prevent
induced
noise. Pre-amp input jacks require a length of high quality
shielded
male to male RCA patch cord.
3
Advertisement
