Page 1
Digital Audio Bass Enhancer Driver with Remote Control...
Page 2
The HTGBD1 has the ability to produce large amount of deep, mind shattering bass without damaging your speakers. The Bass Output Control circuit allows the HTGBD1 to maximize the bass output of any auto sound audio system while restraining destructive bursts. www.Lanzar.com...
Page 3
Often a higher frequency actually sounds louder and cleaner. 7. Bass Maximize Indicator: These three LED indicators ashes when the bass maximization circuit is activated. 8. Power On LED www.Lanzar.com...
Page 4
In most systems the factory setting will suit you ne. We recommend you try the factory setting rst. www.Lanzar.com...
Page 5
Connect a red wire to the car battery or other power source. • REMOTE Connect an orange wire to remote activating (12V DC) wire of car stereo or equalizer. • Connect a black wire to the car chassis for ground connection. www.Lanzar.com...
SIGNAL CONNECTIONS NOTE For signal connection, the output RCA connectors should be connected to the next component after the HTGBD1, such as a crossover, equalizer, or ampli er. Just remember, the HTGBD1 should go inline before a crossover. www.Lanzar.com...
6. Verify that the GND connection is secure, the conductor (wire) is not too thin and unnecessarily long. 7. Check that the B+ wire is not too thin and unnecessarily long. 8. Change the power source; try taking power from a di erent point. INSTALLATION TAPPING SCREW SPRING WASHER PLAIN WASHER www.Lanzar.com...
Page 9
• Frequency Response: 10 – 30 KHz • Distortion: 0.05% THD at 1V output level • S/N Ratio: 130dB • Separation: >60dB • Voltage: 11V-15V • Product Dimensions (L x W x H): 7.5'' x 5.4'' x 1.1'' -inches www.Lanzar.com...
Page 10
Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@lanzar.com...