Operating Other Equipment With The Cinemastation Remote Control; Storing Manufacturer Codes In The Remote Control; Setting The Manufacturer Code - Yamaha DVX-S120 Owner's Manual

Storing Manufacturer Codes in the Remote
Control

Setting the Manufacturer Code

DVR-S120 WB56650
POWER
AUDIO ANGLE
/DTS SELECT MATRIX 6.1
REPEAT
NIGHT
SW CENTER
TV INPUT
TV CH
A B C D E
PRESET
ON SCREEN
CH
ENTER
STATUS
TV VOL
MUTE
AMP
DVD/CD
VCR
TUNER
MOVIE MUSIC SPORTS
CINEMA
If you set the manufacturer code (a unique code assigned to each
manufacturer) in the CinemaStation Remote Control, you can operate a
connected television, VCR, CD or MD recorder with the Remote Control.
Note
• Depending on the model, the Remote Control may not work, or only work with a limited
number of functions. In this case, use the remote control that came with the television, VCR,
CD or MD recorder.
POWER
TV
TV
SUBTITLE
Number
STEREO
A-B
buttons
SURR
SHIFT
SHIFT
SLEEP
PRESET
MENU
SET MENU
CH
RETURN
TEST
VOLUME
VIDEO
VCR
GAME

Operating Other Equipment with the CinemaStation Remote Control

When a manufacturer code is set for the TV button or VCR
button, you can begin using the features described in
"Available Operations" on page 84.
Note
• For the TV button you can only set a television manufacturer code and
for the VCR button you can only set a VCR, CD or MD recorder
manufacturer code.
While holding down SHIFT, press TV or VCR.
Each button can be assigned one manufacturer code.
Note
• Perform steps 1 to 2 while holding down SHIFT.
While holding down SHIFT, enter the
manufacturer code (3 digits) of the device with
the Number buttons.
For details, refer to "Manufacturer Code List" on
pages 86 and 87.
When the setting succeeds, "Code Set OK" appears;
however, when it does not, "Code Set NG" appears in the
CinemaStation Display. If setting is unsuccessful,
perform steps 1 and 2 again.
When finished entering the code, release your finger from
SHIFT.
Advice
• The TV button has 299 and the VCR button has 399 as the factory
default setting for manufacturer code.
Make sure that you set the correct manufacturer
code.
With a manufacturer code set for the TV button, press the
button to turn the TV power on/off (standby), and check
that the setting is working correctly.
With a manufacturer code set for the VCR button, press
the button then the features described in "Available
Operations" on page 84, and check that the setting is
working correctly.
83