Configuration Information - Factory Integrated Models - HP ProLiant DL320e Specification
Entry-level single processor 1u short depth rack server
Hide thumbs
Also See for ProLiant DL320e:
- User manual (103 pages) ,
- Specification (45 pages) ,
- Quickspecs (41 pages)
Table of Contents
Advertisement
QuickSpecs
Configuration Information - Factory Integrated Models
NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on
configurable product offerings and requirements.
NOTE: Factory Integrated Models must start with a CTO Server.
NOTE: FIO indicates that this option is only available as a factory installable option.
NOTE: All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
Step 1: Base Configuration (choose one of the following configurable models)
HP Models
HP ProLiant DL320e Gen8 v2 Non-hot Plug 2 LFF Configure-to-order Server
Factory Integrated Model ships with:
1U Chassis with 2 LFF Non-Hot Plug Drive Cage
HP Ethernet 1Gb 2-port NC332i Adapter
HP iLO Management Engine (standard)
HP Dynamic Smart Array B120i SATA Controller (RAID 0/1/10)
NOTE: For set up instructions for HP Dynamic Smart Array B120i SATA Controller please
refer to the HP ProLiant DL300 series server user guide
NOTE: For general information about HP Dynamic Smart Array B120i SATA Controller,
please visit:
http://h18004.www1.hp.com/products/servers/proliantstorage/arraycontrollers/
smartarrayb120i/index.html
HP ProLiant DL320e Gen8 v2 Hot Plug 2 LFF Configure-to-order Server
Factory Integrated Model ships with:
1U Chassis with 2 LFF Hot Plug Drive Cage
HP Ethernet 1Gb 2-port NC332i Adapter
HP iLO Management Engine (standard)
HP Dynamic Smart Array B120i SATA Controller (RAID 0/1/10)
NOTE: For set up instructions for HP Dynamic Smart Array B120i SATA Controller please
refer to the HP ProLiant DL300 series server user guide
NOTE: For general information about HP Dynamic Smart Array B120i SATA Controller,
please visit:
http://h18004.www1.hp.com/products/servers/proliantstorage/arraycontrollers/
smartarrayb120i/index.html
HP ProLiant DL320e Gen8 v2 Hot Plug 4 SFF Configure-to-order Server
Factory Integrated Model ships with:
1U Chassis with 4 SFF Hot plug Drive Cage
HP Ethernet 1Gb 2-port NC332i Adapter
HP iLO Management Engine (standard)
HP Dynamic Smart Array B120i SATA Controller (RAID 0/1/10)
NOTE: For set up instructions for HP Dynamic Smart Array B120i SATA Controller please
refer to the HP ProLiant DL300 series server user guide
NOTE: For general information about HP Dynamic Smart Array B120i SATA Controller,
please visit:
http://h18004.www1.hp.com/products/servers/proliantstorage/arraycontrollers/
smartarrayb120i/index.html
DA - 14563 North America — Version 8 — December 13, 2013
HP ProLiant DL320e Generation 8 (Gen8) v2
722313-B21
722314-B21
722315-B21
Page 21
Advertisement
Table of Contents
