Panasonic WV-CL930 Operating Instructions Manual page 8

Turn the circuit breaker off which supplies
this product with the power when abnor-
mal conditions are encountered.
Avoid installing in the following locations.
• Locations where it may get wet from rain
or water splash
• Locations where a chemical agent is
used such as a swimming pool (not only
outdoor)
• Locations subject to steam and oil smoke
such as a kitchen
• Locations near flammable gas or vapor
• Locations where radiation or x-ray emis-
sions are produced
• Locations subject to strong magnetic
field or radio waves
• Locations where corrosive gas is pro-
duced
• Locations where it may be damaged by
briny air such as seashores
• Locations where the temperature is not
within –10 °C to +50 °C {14°F to 122°F}.
• Locations subject to vibrations (This
product is not designed for on-vehicle
use.)
• Locations subject to condensation as the
result of severe changes in temperature
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your partic-
ular environment.
Make sure that the installation area is strong
enough to hold this product, such as a con-
crete ceiling.
Do not install this product in a humid or
dust-laden environment.
Otherwise, lifetime of the internal parts may
be shortened.
Be sure to remove this product if it is not
in use.
Radio interference
When this product is used near TV/radio
antenna, strong electric field or magnetic
field (near a motor or a transformer), images
8
may be distorted and noise sound may be
produced.
Mounting screws
Only the fixing screws are provided to fix this
product with the camera mounting base. It is
necessary to procure screws or bolts to
mount this product. Prepare them according
to the material and strength of the area where
this product is to be installed. The screws
and bolts must be tightened with an appro-
priate tightening torque according to the
material and strength of the installation area.
Do not operate this product beyond the
specified temperature, humidity or power
source ratings.
Use this product at temperatures within
–10 °C to +50 °C {14°F to
ty below 90 %. The input power source is
12 V DC/24 V AC (WV-CL934) or 120 V AC
(WV-CL930).
Avoid connections during a lightning
storm.
Otherwise, an electric shock may be caused.
122°F}, and humidi-