Panasonic WV-CL930 Operating Instructions Manual page 14

Installation
position
On ceiling
On wall
For some applicable mounting bases, "A" is attached to the model number. The mounting con-
ditions are the same even for the A-attached models.
• When the tripod socket is mounted on
the top of the camera, be sure to use the
screws that were removed from the tri-
pod socket. Use of longer or shorter
screws may cause drop or damage.
(Recommended tightening torque: 0.39
N·m {0.29 lbf·ft})
v
Establish the connection of a coaxial cable (locally procured).
Important:
• Be sure to turn off the power of each device before connection.
Connect a coaxial cable (locally procured) to the video output connector. If the synchroniz-
ing signal input is provided from an external device, connect another coaxial cable to the
external synchronization input connector.
120V ~ 60Hz
Important:
• Be sure to secure the coaxial cable connectors.
14
Applicable Recommend-
mounting base
WV-7011
WV-7010
WV-7012
WV-831
WV-7013
GEN-LOCK VIDEO OUT
POWER
GND
ALARM
OUT
DAY/ GND
NIGHT
IN
(This illustration represents WV-CL930.)
Screw
ed screw quantity
M6 4 pieces
M8 3 pieces
M6 3 pieces
M8 4 pieces
M6 3 pieces
Tripod socket hole:
1/4-20 UNC
Coaxial cables (locally procured)
Minimum pull-out
strength (per 1 screw)
196 N
196 N
196 N
921 N
2.25 kN
From external synchronization source
(VBS/VS)
To video input (CAMERA IN)
{44 lbf}
{44 lbf}
{44 lbf}
{207 lbf}
{505 lbf}
Screws
Tripod socket