Chapter 3. Operation
MENU ITEM
1 kHz Tone
View Sig Bits
Set TX Signal
Set 2W Output
24
VIEW SIG BITS (View Signaling Bits)
View Sig Bits is used to view the status of the RX and TX
signaling bits in the DS-1 stream. See Figure 3-8. The
status of both the A and B bits is displayed.
SET TX SIGNAL (Set Transmit Signal)
Set TX Signal allows the A and B signal bits in the TX
direction to be forced to a desired state for test.
SET 2-W OUTPUT (Set 2-Wire Output)
Set 2W Output allows the 2-wire voice interface output
to be forced to a desired state for test.
PARAMETER CHOICES
Off, Near, Far
Display only
Off, A=0 B=0, A= B=0, A= B=1, A=1 B=1
Off, Disabled, Tip Open, Active, Ringing
FXS+ Dual Voice Option Module
Figure 3-8
View Signaling Bits Display
Table 3-B
Port Test Parameters
61200.080L1-1