Port Test
1)NETWORK TESTS
4)TEST
2)RUN SELF TEST
3)PORT TEST
4)CANCEL TEST
61200.080L1-1
Port Test, a submenu of the TSU 100/600 Main menu
item Test, activates tests of the selected data ports.
Selecting the FXS+ displays tests available for this option
module. See Figure 3-7 and Table 3-B.
When Port Test is displayed, place the cursor on it and
press Enter to display the first available port. Scroll to
select 1.1 FXS+ and press Enter to activate the following
submenu items:
• 1 kHz Tone
• View Sig Bits
• Set TX Signal
• Set 2W Output
These items are discussed in the following pages.
1 kHz Tone
This test injects a 1 kHz sine wave either toward the far
end (TX direction toward the T1 network) or toward the
near end (the 2-wire interface on the option module).
This tone may be used for testing or relative level
measurements. When 1 kHz Tone is enabled, ringback
and dial tone for other channels on the slot are sus-
pended.
Choices include:
• Off
• Near
• Far
FXS+ Dual Voice Option Module
Chapter 3. Operation
1)1 KHZ TONE
2)VIEW SIG BITS
1.1 FXS+
3)SET TX SIGNAL
4)SET 2W OUTPUT
Figure 3-7
Port Test Submenus
23