Self Help - Bosch SHE43R52UC Use And Care Manual

To avoid injury, do not reach into the large object trap with your fingers. The
large object trap could contain sharp objects.
To remove the Large Object Trap, remove the bottom rack. Grasp the assembly
and turn it counterclockwise. Lift the assembly out.
Carefully examine the assembly. If you find debris in the Large Object Trap,
turn it upside-down and gently tap it on a flat surface to dislodge and remove
debris.
Remove the Micro Filter as shown in Figure 13.
Flush the Micro Filter and Fine Filter clean by holding them under running water.
To reinstall the filter system, return the Micro Filter to the installed position. Place the Large Object Trap/Cylin-
der Filter Assembly and Fine Filter into the installed position. Turn the locking nut clockwise until it is locked.
The arrow on the ring handle and the arrow on the Fine Filter should point at each other.
Clean the exterior door panel
Colored doors: use only a soft cloth dampened with soapy water.
Stainless steel doors: use a soft cloth with a non-abrasive cleaner (preferably a liquid spray) made for cleaning
stainless steel. For the best results, apply the stainless steel cleaner to the cloth and then wipe the surface.
Clean the door gasket
Regularly clean the door gasket with a damp cloth to remove food particles and other debris. Also clean the door
seal, located inside the dishwasher at the bottom of the door.
Winterizing your unit
If your dishwasher will be unused for an extended period of time in a location that experiences freezing tempera-
tures (holiday home or through a vacation period), have your dishwasher winterized by an authorized profes-
sional service. Turn your household water supply to the dishwasher off when on extended vacation or when
dishwasher will not be used for more than 1 month.

Self Help

Dishwashers may occasionally exhibit problems that are unrelated to a malfunction of the dishwasher itself. The
following information may help you with a dishwasher problem without involving a repair professional.
Problem
1. Door may not be properly latched
2. Unit may not be turned on
3. Unit not reset or previous cycle not completed
4. Delay start engaged
Dishwasher
5. Interruption of electrical power supply to dish-
does not start
washer or blown fuse.
6. The door may have been closed without first
selecting a cycle
7. Water supply may not be turned on
Dishwasher 1. Default factory settings alert the customer that
beeping (end of the cycle is complete by beeping. This feature can be
cycle signal) deactivated if so desired.
Display does 1. A fuse may have been blown or circuit breaker
not illuminate tripped
2. Door not closed or latched
Note: For models with controls on top of the door, the
display only illuminate when the door is opened and
controls are visible.
14
CAUTION
Cause
1. Shut the door completely until you hear it click.
2. Press the main power switch to turn unit on.
3. To reset, refer to "Cancel a Cycle" (page 12) in this manual.
4. To reset, refer to "Delay Start" (page 12) section in this manual.
5. Check circuit breaker
6. Select a cycle and close the door.
7. Check and turn on water supply.
1. To adjust the volume or deactivate, refer to the "Cycle Comple-
tion Signal" (page 13) section in this manual.
1. Check the fuse or circuit breaker box and replace the fuse or
reset the breaker if necessary
2. Ensure door is properly latched and completely closed
Figure 13
Action
Micro
Filter