Table of Contents
Advertisement
Search Mode Operations
5. MOTION DETECTION SEARCH
If a motion sensor has been set to detect movement in a particular camera view, and images for that
view have been saved in the normal recording area or alarm recording area, you can search for those
images that have changed as a result of movement by an intruder, for example, and play back those
images.
1
Select [MOTION DETECTION SEARCH] from the
[SEARCH] menu.
The MOTION DETECTION SEARCH screen will be
displayed.
2
Select the recording area to search for images
from the [SEARCH FROM] menu.
• ALARM:
Only alarm recording area images will be
searched.
• NORMAL: Only normal recording area images will be
searched.
• ALARM AND NORMAL: Images in both the alarm
recording area and the normal recording
area will be searched.
3
Select the channel (camera number) to search
for images from the [MULTIPLEXER CHANNEL]
menu.
If the multiplexer function has not been used and only one
channel is available, [--] will be displayed.
4
Click the [SET] button. The recording start and
recording end times for the images to be
searched will be displayed in the [START] and
[END] menus respectively. To refine the range
over which to search, use the menu to adjust the
[START] or [END] settings, and then click the
[SET] button to apply the changes.
The search results will be displayed in a message box.
5
Specify the motion sensor search conditions.
• Sensor position
The MOTION SENSOR SET screen will be displayed,
and it will be divided up into an 8 (H) × 10 (W) grid. Click
the position where you wish to set the focus for the
motion sensor. A red sensor setting mark will appear at
that position. (If you click a sensor position again, the
sensor setting will be canceled.)
• Sensor level
Select from the menu. The lower the number, the higher
is the sensitivity.
6
Click the [PREVIEW] button to confirm the image
in the PREVIEW screen.
Images in the specified time range in which the sensor has
detected movement will be searched and displayed on the
PREVIEW screen.
7
After confirming that the image found is the one
you wish to play back, click the PREVIEW
screen.
The images starting from the point that the alarm occurred
will be played back in a single-screen display.
English
1
2
3
5
1
SEARCH FROM
This selects the recording areas to search in.
2
MULTIPLEXER CHANNEL
Channel (camera number) for images to be searched
3
START/END
This selects the recording start and end times for the
images to be searched.
4
SET
This sets the search conditions.
5
MESSAGE BOX
This shows the search results for images that satisfy the
search conditions.
• Searching for images: SEARCHING
• Images satisfying the search conditions have been
found: FOUND
• No images that satisfy the search conditions were
found: IMAGES NOT FOUND !
6
MOTION SENSOR SET
Motion sensor setting screen
7
MOTION SENSOR LEVEL
Sets the sensor sensitivity.
(OFF, 1 to 10)
8
PREVIEW
Search image preview display.
29
4
6
7
8
Advertisement
Table of Contents
