Ntp Configuration Menu (Sip Phones Only); Ui Configuration Menu - Cisco 7945G Administration Manual

Device Configuration Menu

NTP Configuration Menu (SIP Phones Only)

The NTP Configuration menu displays information about the NTP server and mode configuration used
by SIP phones.
Table 4-11 NTP Configuration Menu Options
Option Description
NTP Server 1 IP address of the primary NTP server.
NTP Server 2 IP address of the secondary or backup NTP server.
NTP Mode 1 Primary server mode. Supported modes are Directed
Broadcast, Unicast, Multicast, Any cast.
NTP Mode 2 Secondary server mode. Supported modes are Directed
Broadcast, Unicast, Multicast, Any cast.

UI Configuration Menu

The UI configuration menu displays the status of various user interface features on the phone.
describes the options on this menu.
Table 4-12 UI Configuration Menu Options
Option Description
Auto Line Select Indicates whether the phone shifts the call focus to
incoming calls on all lines.
When this option is disabled, the phone only shifts the call
focus to incoming calls on the line that is in use. When this
option is enabled, the phone shifts the call focus to the line
with the most recent incoming call.
Default: Disabled
BLF for Call Lists Indicates whether the Busy Lamp Field (BLF) is enabled
for call lists.
Reverting Focus Indicates whether the phone shifts the call focus on the
Priority phone screen to an incoming call or a reverting hold call.
Settings include:
Lower—Focus priority given to incoming calls.
Higher—Focus priority given to reverting calls.
Even—Focus priority given to the first call.
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.1(3)
4-18
Table 4-11 describes the options on this menu.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
Use Cisco Unified Communications
Manager Administration to modify.
Use Cisco Unified Communications
Manager Administration to modify.
Use Cisco Unified Communications
Manager Administration to modify.
Display only—cannot configure.
To Change
From Cisco Unified Communications
Manager Administration, choose
Device > Phone > Phone Configuration.
From Cisco Unified Communications
Manager Administration, choose
System > Enterprise Parameters.
From Cisco Unified Communications
Manager Administration, choose System
> Device Pool.
See also: Hold Reversion.
Table 4-12
OL-17755-01