Chauvet Legend 230SR Beam Quick Reference Manual page 3

EN
Lamp
Replacement
DMX Linking
DMX Connection
1. Turn the fixture off and disconnect it from power.
2. Wait at least 15 minutes for the lamp to cool down.
3. Remove both head covers by removing 8 Phillips-head ¼-turn screws.
4. Orient the rear of the product so that the fan is facing upward.
5. Remove the 2 Phillips-head screws on the sides of the fan assembly.
6. Roll the fan assembly to the right to expose the lamp.
7. Using the lamp base, push the lamp down against the spring clips
located on the bottom, then roll the lamp out the top.
8. Remove the 2 wires connected to the lamp by the spade connectors.
9. Reverse the steps above to install the new lamp.
Please refer to the User Manual for more detailed instructions with
images.
The Legend™ 230SR Beam will work with a DMX controller using a
regular DMX serial connection. A DMX Primer is available from
www.chauvetpro.com.
The Legend™ 230SR Beam uses a regular DMX data connection for its
DMX personalities: 15- and 18-channel modes. See the User Manual to
connect and configure for DMX operation.
Legend™ 230SR Beam QRG
3
¼-turn
Phillips-head
screws