Introduction; Packing; Unpacking; Temporary Storage - Garland CXBE12 Installation & Operation Manual

INSTALLATION OPERATION MANUAL

INTRODUCTION

GARLAND RECOMMENDS THAT INSTALLATION, MAINTENANCE AND REPAIRS BE DONE BY AN
AUTHORIZED SERVICE AGENCY, OTHERWISE THE WARRANTY WILL BE DEEMED NULL AND
VOID. FOR A LIST OF AUTHORIZED SERVICE AGENTS, REFER TO THE GARLAND WEB SITE AT
http://www.garland-group.com.
This appliance should be given regular care and maintenance to operate at peak performance and
maximum energy effi ciency. It is recommended that the unit be inspected every 6 months by a
certifi ed service technician for proper operation and performance. Remember "regular maintenance
ensures peak performance. "
Every broiler is inspected and tested at the factory prior to shipment.

Packing

The product is shipped in a substantial crate with
the broiler in vertical position. Casters are factory
installed on the broiler. Garland places the unit/
accessories in the crate in a neat and organized
manner and in such a way as to eliminate
damage from movement, rubbing etc.
Check crate for any visible damage sustained
during transit.
It is recommended to remove crate when the
clamshell broiler is inside the kitchen.

Unpacking

CAUTION
Heavy load
Use of lifting aids
and proper lifting
technique required
Carefully remove unit from crate and thoroughly
inspect it for any visible or concealed damage.
Report any damage immediately to your carrier
to fi le the appropriate freight claims. For more
information, see page 4. Push or pull broiler must
be taken care to see that the broiler does not tip
over.
Page 8
GARLAND ELECTRIC CLAMSHELL BROILER, CXBE12 MODEL
Do not remove any permanently affi xed labels,
warnings or data plates from the appliance as
this may invalidate the Garland warranty.

Temporary Storage

Garland provides adequate protection under
normal conditions. The broiler may need
additional protection if it is stored near salt water,
a tropical area, or other unfavorable conditions.
You must contact Garland immediately if these
conditions occur.

Safety

It is essential that the instructions in this manual
be strictly followed for the safe and economical
operation of the equipment. Should it be
known or suspected that a fault exists with the
appliance, then it must not be used until the fault
is rectifi ed by a authorized or certifi ed service
person.
This appliance provides a sleep mode which
ensures the unit avoids overheating when idle.
Part #4532096 Rev 6 (25 Oct 2013)