Bosch UML-463-90 User Manual page 32

32 en | Navigating the Monitor
Power Save
Control Setting
Network Settings
Set Monitor ID
HDMI Control
2013.07 | v1.0 | F.01U.286.147
Sets the display to enter the power saving mode when there is no
signal detected (see also Power Management, page 34).
Low: All signal sources can enter the power saving mode and wake up
the display.
High: All signal sources can enter the power saving mode, but only a
VGA signal can wake up the display, or you must press the power
button to wake up the display when other source is connected.
Off: If no signal source is detected, the backlight will stay on.
Note:
Serial can bring any mode out of the power saving status.
LAN can bring Low mode out of the power saving status.
RS-232C/LAN: Choose a terminal to control the display.
IR Pass through: Select if multiple displays are connected via RS-232C
cables:
– Primary: Designate the display as the primary unit for remote
control operation. Only this display will be operated by the
remote control.
– Secondary: Designate the display as the secondary unit. The
display can not be operated by the remote control, and will only
receive the control signal from the primary display via the RS-232
connection.
Note:
To reset to the default setting (RS-232C), press INFO on the remote
control for 5 seconds
See Connecting to the network (LAN), page 21.
Sets the ID number for controlling the monitor when multiple
monitors are connected under the RS-232C control mode. Each
monitor must have a unique ID number (this will define its position
within the matrix). For example: starting on the top row (working left
to right), the top left monitor can have an ID of 1; when you reach the
end of the row, the next number will refer to the monitor one row
down, starting at the left.
Uses the HDMI CEC (Consumer Electronics Control) industry standard
protocol to share functionality between connected devices and the
monitor. This means you can send system commands to the monitor
and a connected device using one remote control as follows
– Connect an HDMI cable between the monitor and a device
equipped with HDMI CEC.
– Make sure On is selected for this menu option HDMI Control.
User Manual
High Performance HD LED Monitor
Bosch Security Systems