C Inserting The Charcoal Water Filter - Cuisinart DGB900BCU Instruction Manual

C Inserting the Charcoal water filter
N.B. Your appliance is supplied with two charcoal water filters.
It is strongly recommended that the water filter is replaced after 90 days or 90 uses; more often if you
have hard water. Failure to do so can lead to a build-up of lime scale and affect the performance of
your appliance. Replacement filters can be purchased directly from the manufacturer, (see "UK After
Sales Service" section for further details).
ß Remove the filter from its packaging and soak in cold tap water for 15 minutes.
ß To remove the water filter holder, simply lift it out from its opening on the inner wall of the
reservoir.
ß Hold stem in one hand. With your other hand, gently press the compartment door down and pull
outwards to flip open.
ß Place the filter in the holder and close the compartment cover; you will hear a snap indicating filter
is in place.
N.B. Caution must be used when inserting the charcoal filter. Improper placement in the holder can
cause tearing of the filter skin.
ß Hold the filter under cold running tap water for 10 seconds to flush. Hold the water filter holder hori-
zontally, directly under the water stream so that the water flows through the filter compartment.
ß Allow the filter to drain completely.
ß Replace the water filter holder into its opening on the inner wall of the reservoir, pushing it all the way
down to the base of the unit.
13