Table of Contents
Advertisement
Insert the key fully into the console.
1
Inserting the key will
not turn on the dis-
play. The display will
turn on when the
ON/RESET button is
pressed or when the
walking belt starts.
Note: If you just in-
stalled batteries, the display will already be on.
Reset the console and start the walking belt.
2
Turn the speed
control to the reset
position. Note: Each
time the walking
belt is stopped, the
speed control must
be turned to the
reset position be-
fore the walking belt
can be restarted.
Next, slowly turn the speed control until the walk-
ing belt begins to move at slow speed. Carefully
step onto the walking belt and begin exercising.
Change the speed of the walking belt as desired
by turning the speed control.
To stop the walking belt, step onto the foot rails
and turn the speed control to the reset position.
Note: The first time the treadmill is used, inspect
the alignment of the walking belt, and align the
walking belt if necessary (see page 13).
Follow your progress with the monitor modes
3
When the power is turned on, the console will au-
tomatically scan through five modes. A flashing
mode indicator will show which mode is currently
displayed. The modes are described below.
• Speed—This mode
shows your speed,
in miles per hour.
• Time—This mode
shows the elapsed
time. Note: If you
stop exercising for
ten seconds or longer, the time mode will pause.
• Distance—This mode shows the total number of
miles you have walked or run.
• Fat Calories (FAT CALS)—This mode shows the
Reset
Mode Indicator
10
approximate number of fat calories you have
burned. (See BURNING FAT on page 14.)
• Calories (CALS)—This mode shows the approxi-
mate number of calories you have burned.
If desired, reset the display by pressing the
ON/RESET button.
When you are finished exercising, stop the
4
walking belt and remove the key.
Step onto the grip tape, stop the walking belt, and
remove the key from the console. The display will
turn off a few minutes after the key is removed.
Note: The display will automatically turn off to
conserve the batteries any time that the walk-
ing belt is stopped and the ON/RESET button
is not pressed for a few minutes.
HOW TO CHANGE THE INCLINE OF THE TREADMILL
To vary the intensity of your exercise, the incline of the
treadmill can be changed. There are three incline lev-
els. Before changing the incline, remove the key
and unplug the power cord. Next, fold the treadmill
to the storage position (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 11).
To change the incline, remove the incline pin from one
of the incline legs as shown below. Adjust the incline
leg to the desired height and fully reinsert the incline
pin. Make sure that the incline pin is in the "locked" po-
sition shown in the inset drawing. Adjust the other in-
cline leg in the same way. Make sure that both in-
cline pins are inserted from the direction shown.
Incline
Pin
CAUTION: Before using the treadmill, make sure
that both incline pins are fully inserted at the same
height. Do not use the treadmill with the incline
pins removed. After you have adjusted the incline
legs, lower the treadmill (see HOW TO LOWER THE
TREADMILL FOR USE on page 11).
Incline
Pin
Incline
Pin
Hide quick links:
Advertisement
Table of Contents
