Assembly - Weslo Cadence 1000 Fm User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included hex keys
cutters , and needlenose pliers
For help identifying the assembly hardware, see the PART IDENTIFICATION CHART in the centre of this
manual.
1. Make sure that the power cord is unplugged.
Place the Base (79) in the position shown, with the indi-
cated small holes on top. Next, place the Wheels (63)
into the ends of the Base.
Attach the Wheels (63) to the Base (79) with 2" Bolts
(61) and Wheel Nuts (64). Make sure that the Wheel
Nuts are on the sides shown; do not overtighten the
Bolts; the Wheels should turn freely.
Attach the four Base Pads (73) to the Base (79) with four
1" Tek Screws (60) (three are shown).
2. Raise the Base (79) to a vertical position, and hold it
near the treadmill Frame (96) as shown. Make sure that
the Wheels (63) are in the indicated position.
Identify the Right Upright (104), which has a large round
hole in the indicated location. Feed the Wire Harness
(65) into the hole and out of the top of the Right Upright.
Make sure that there are two U-nuts (74) in the lower
end of the Right Upright (see drawing 2a). Hold the Right
Upright against the Base (79) as shown. Make sure that
the Right Upright is oriented so the pivot hole is in the
position shown. Hand tighten two 3" Bolts (58) with two
5/16" Star Washers (57) into the Base and the Right
Upright.
Attach the Left Upright (47) to the Base (79) in the same
way. Note: There is not a wire harness on the left side.
With the help of a second person, raise the Uprights (47,
104) to a vertical position.
and your own phillips screwdriver
.
1
61
63
2
47
2a
104
74
6
Small Hole
60
73
79
64
60
73
64
63
58
57
79
104
Pivot
Holes
96
, wire
60
73
61
58
57
Round
Hole
65
63