Connecting An Alarm Trigger - Bosch UML-262-90 User Manual

Full HD LCD Monitors
5.7

Connecting an Alarm Trigger

The monitor contains an alarm Trigger Input and a Trigger
cable. These components allow you to connect an alarm relay
from a device, such as a camera or a door. Connect the two
flying leads from the Trigger cable into the relay out ports of the
device. Then, route the other end of the cable to the Trigger
Input connector on the back panel of the monitor.
The following illustration depicts a typical alarm relay
configuration:
Figure 5.9 Camera to Monitor Alarm Relay
Number Description
1
2
3
In the above example, the flying leads of the Trigger cable are
connected to Trigger outputs three (3) and four (4) of a Dinion
camera. The cable is routed to the back panel of the UML
monitor and the plug-end of the wire is connected to the
Trigger Input port.
Example: Typical Alarm Trigger Configuration
In this case, the Dinion camera is used to watch for motion.
When the camera detects motion it sends an alarm to the UML
monitor. The monitor, then, switches the input to display the
video from the Dinion camera and sounds a buzzer.
1.
Bosch Security Systems, Inc.
Dinion Camera
Flying leads connected to Trigger outputs 3 and 4
UML Back Panel
Route the coax cable from the Dinion Video output to the
AV1 input of the UML monitor.
User's Manual
Installing the Monitor | en
F.01U.172.600 | 1.0 | 2010.10
33