Notes On The Documentation; Storing Documents; Symbols Used; Applicability Of The Instructions - Vaillant ecoTEC VU Installation And Maintenance Instructions Manual

1

Notes on the documentation

1 Notes on the documentation
The following instructions are intended to guide you
throughout the entire documentation. Further documents
apply in combination with these installation and mainte-
nance instructions.
We accept no liability for any damage caused by non-
observance of these instructions.
Other applicable documents
> When installing the ecoTEC, follow all installation instruc-
tions for the various parts and components of the sys-
tem without exception.
These installation instructions are enclosed with the various
system components as well as additional components.
> Also observe all the operating instructions included with
the system components.
1.1

Storing documents

> Pass these installation instructions and all other applica-
ble documents and, if necessary, any required aids to the
system operator.
The system operator should retain these instructions and
tools so that they are available when required.
1.2

Symbols used

The symbols used in the text are explained below:
i
Symbol that denotes useful tips and
information
>
Symbol for a required action
1.3

Applicability of the instructions

These installation instructions are only valid for boilers with
the following article numbers:
Boiler Type designation
ecoTEC 22 (VU GB 226/5-3)
ecoTEC 26 (VUW GB 266/5-3)
1.1 Appliance types and article numbers
The article number of the boiler can be found on the identi-
fication plate.
4
1.4
The identification plate of the Vaillant ecoTEC is attached
to the underside of the boiler in the factory.
The article number of the gas fired wall hung boiler can be
found in the serial number. The seventh to sixteenth num-
bers constitute the article number.
The serial number can also be found on the lift out badge
located at the bottom of the front casing of the boiler.
The serial number can also be shown on the display of the
boiler (¬ Operating instructions).
1.5
The conformity declaration can be checked with the manu-
facturer.
1.6
Vaillant Ltd. supports the Benchmark Initiative.
You will find the Benchmark Logbook on the last pages of
this instruction manual. It is very important that this docu-
ment be filled out properly when installing, commissioning,
and fully explained at hand over to the operator of the
installation. Installers should point out also the service
record section for completion following service calls to this
appliance.
Vaillant Ltd. is a licensed member of the Benchmark
Scheme which aims to improve the standards of installation
and commissioning of domestic heating and hot water sys-
tems in the UK and to encourage regular servicing to opti-
mize safety, efficiency and performance. Benchmark is
managed and promoted by the Heating and Hot water
Industry Council.
> For more information visit www. centralheating .co .uk
Article number
0010015190
0010015189
i

Identification plate

CE label

The CE label shows that the products comply
with the basic requirements of all applicable
directives as stated on the identification
plate.

Benchmark

Vaillant supply a special self adhesive sticker on
top of the boiler for use in entering the serial
number details straight onto the commissioning
checklist found in the last pages of this docu-
ment.
Installation and maintenance instructions ecoTEC 0020173113_01