Chrysler 200 Convertible User Manual page 38

Phone Pairing
NOTE: Pairing is a one-time initial setup before using the phone. You will also need to follow the
Bluetooth® instructions in your cell phone user guide to complete the phone pairing setup.
• Press the Phone button
• Wait for the "ready" prompt and BEEP.
• (After the BEEP), say "Uconnect setup".
• (After the BEEP), say "phone pairing".
• (After the BEEP), say "pair a phone".
• Follow the audible prompts.
• You will be asked to enter a four-digit Personal Identification Number (PIN), which you will later
need to enter into your mobile phone. You can enter any four-digit PIN. You will not need to
remember this PIN after the initial pairing process.
• You will then be prompted to give the phone pairing a name (each phone paired should have a
unique name).
• Next you will be asked to give this new pairing a priority of 1 thru 7 (up to seven phones may be
paired); 1 is the highest and 7 is the lowest priority. The system will only connect to the highest
priority phone that exists within the proximity of the vehicle.
Making A Phone Call
• Press the Phone button
• (After the BEEP), say "dial" (or "call" a name).
• (After the BEEP), say number (or name).
Phonebook Edit
• Press the Phone button
• (After the BEEP), say "phonebook".
• (After the BEEP), say "new entry" or "list names" or "delete".
• Follow the prompts.
Receiving A Call – Accept (And End)
• When an incoming call rings/is announced on Uconnect™, press the Phone button
• To end a call, press the Phone button
Mute (Or Unmute) Microphone During Call
• During a call, press the Voice Command button
• (After the BEEP), say "mute" (or "mute off").
Transfer Ongoing Call Between Handset And Vehicle
• During a call, press the Voice Command button
• (After the BEEP), say "transfer call".
36
ELECTRONICS
to begin.
.
.
.
.
.
.