Axminster AWHBS350N Instructions Manual page 11

Fitting the guide fence
Fit the guide fence by clipping the rear clamp over
the back rail first and dropping the front clamp over
the fence rail. (See fig 6) Push down on the lock lever,
and ensure the fence clamps up correctly.
(See fig 6a).
Check the guide fence is set parallel to the
Fig 6
Guide fence
Fig 6b
Fitting NVR switch shroud
Fig 7
Remove the two Phillips screws from either side of the switch assembly, see fig 7, slide the switch shroud over
the switch, see fig 7a and secure using the two Phillips screws you removed earlier.
Magnifying
Guide bearing
blade. Any slight discrepancy can be taken out by
loosening the 4 butterfly bolts that secure the blade
of the guide fence to the clamping body, adjust and
re-tighten. Larger discrepancies may require that the
fence rail is angled slightly.
The dimensioning scales have adjustable index plates
set in the fence guide front clamp body to enable the
scales to be zero read. (See fig 6c)
Fence rail
Lock lever
glass
Dimensioning scale
Switch
shroud
11
Assembly
Fig 6a
Fig 6c
Fig 7a