5. Orient the Frame (8) so that the hexagonal
holes are on the bottom. Attach the Frame to
the Crossbar (5) with three M10 x 70mm Bolts
(33), two M10 Washers (43), and three M10
Nylon Locknuts (58). Do not tighten the Nylon
Locknuts yet.
6. Tighten the "T"-handle (45) into the Seat
Carriage (42).
Pull the "T"-handle (45) out as far as it will go
and slide the Seat Carriage (42) onto the
Frame (8).
Attach the Front Leg (12) to the Frame (8) with
two M8 x 60mm Bolts (59), two M8 x 65mm
Bolts (46), six M8 Washers (50), and four M8
Nylon Locknuts (49). Do not tighten the Nylon
Locknuts yet.
7. Set the pins on the Adjustment Tube (9) down
into a set of brackets on the Left and Right
Uprights (3, 4).
See steps 1–6. Tighten the M10 Nylon
Locknuts (58) and the M8 Nylon Locknuts
(49) used in these steps.
5
33
8
Hexagonal
Holes
6
49
45
12
7
Pin
4
8
43
33
5
58
33
59
50
50
50
42
50
46
49
9
Pin
3
58
43
8