Weider 220 Bench User Manual page 10

11. Attach the Weight Tube (19) to the Leg Lever
(18) with an M8 x 70mm Bolt (71), two M8
Washers (50), a 17mm x 9mm Spacer (61), and
an M8 Nylon Locknut (49).
Press the 25mm Round Outer Cap (62) onto
the end of the Weight Tube (19).
12. Apply grease to the barrel of an M10 x 70mm
Bolt Set (55). Next, attach the Leg Lever (18) to
the Front Leg (12) with the Bolt Set. Make sure
the barrel of the Bolt Set is inserted through
both sides of the bracket on the Front Leg.
Do not overtighten the Bolt Set; the Leg
Lever must pivot easily.
13. Insert a Pad Tube (24) into either hole in the
Front Leg (12). Slide two Foam Pads (23) onto
the Pad Tube.
Insert a Pad Tube (24) into a hole in the Leg
Lever (18). Slide two Foam Pads (23) onto the
Pad Tube, and press two Pad Caps (68) into
the ends of the Foam Pads. Repeat this step
with the other Pad Tube (24).
14. Insert a Weight Rest (39) into one of the holes
in the Right Upright (4) and engage the locking
bar around the Right Upright. Next, insert a
Safety Spotter (27) into the Right Upright and
engage the locking bar around the Right
Upright.
Repeat this step with the other Weight Rest,
(not shown), the other Safety Spotter (not
shown), and the Left Upright (not shown).
11
49
12
Grease
18
13
23
23
18
68
24
14
39
Locking
Bar
27
10
18
62
50
50
61
71
19
Bracket
55
55
12
24
12
23
4
68