The Console Setup Mode lets you set the units of measure to either English or Metric, change the
machine type, or see maintenance statistics (Error Log and Run Hours – for service technician use
only).
1.
Hold down the Increase button and Decrease button together for 3 seconds while in the
Power-Up Mode to go into the Console Setup Mode.
Note: Push STOP to go back to the previous screen or the Power-Up Mode screen.
2.
The Console display shows the Units prompt. Push START/ENTER to start Units option. Push
the Increase/Decrease buttons to change between "Miles-Lb" (English units) and "Km-Kg"
(metric units).
Note: If the units change when there is data in User Statistics, the statistics change to the new
units.
3.
Push START/ENTER to set.
4.
The Console display shows the Machine Type prompt. Push START/ENTER to start Machine
Type option. Push the Increase/Decrease buttons to change between ELLIPTICAL and BIKE.
5.
Push START/ENTER to set.
6.
The Console display shows the Error Log prompt. Push START/ENTER to start Error Log
option. The Error Log stores the last 10 errors (error type and system time of error), listed
newest to oldest. Push the Increase/Decrease buttons to move through the Error Log. If there
are no errors, the Console display shows "Index=0".
7.
Push STOP to exit.
8.
The Console shows the RUN HOURS prompt. Push START/ENTER to see total hours for the
machine.
9.
Push STOP to exit.
10. The Console display shows the Units prompt again. Push STOP to go back to the Power-Up
Mode screen.
CONSOLE SETUp MOdE
31