Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the elliptical regularly.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
HEART RATE MONITOR TROUBLESHOOTING
If the console does not turn on, make sure that the
power cord is fully plugged in. If lines appear in the
console display, see HOW TO CHANGE CONSOLE
SETTINGS on page 29 and adjust the contrast level
of the display.
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 24.
HOW TO CALIBRATE THE RAMP
If the ramp is not functioning properly, the ramp may
need to be calibrated. To calibrate the ramp, press
and hold the 11 Calorie Workouts button for several
seconds until the test mode appears in the display.
Press the 11 Calorie Workouts button again. Press
the Quick Power Ramp increase or decrease button
to calibrate the ramp. The ramp will move upward and
downward as it calibrates.
When the ramp stops moving, the ramp is calibrated.
Then, press the 11 Calorie Workouts button repeatedly
to exit the test mode.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the
reed switch,
first unplug the
power cord.
Using a flat
screwdriver,
release the tabs
on the Top Cover
(20) and pry
the Top Cover
upward off the
elliptical.
Next, look into the access opening and locate the
Reed Switch (69). Rotate the Large Pulley (74) until a
Magnet (75) is aligned with the Reed Switch.
93 75
69
Next, loosen, but do not remove, the indicated M4 x
16mm Screw (93). Slide the Reed Switch (69) slightly
toward or away from the Magnet (75). Then, retighten
the M4 x 16mm Screw.
Plug in the power cord and rotate the large pulley for
a moment. Repeat these actions until the console
displays correct feedback. When the reed switch is
correctly adjusted, reattach the access cover.
31
20
74
Hide quick links:
Advertisement
Table of Contents
