External Siren Test; Solution 64 User Guide; Internal Siren Test; Strobe Test - Bosch Solution 64 User Manual

Solution 64 User Guide
Outputs > Output Testing >

External Siren Test

This menu allows you to test any external sirens which have been
connected by your installer. The test will last for 5 seconds.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [9] + [0].
If the system has been partitioned, the keypad will
display a list of areas.
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
PRESS

2. Use the [↑] and [↓] keys to select the area that you want
to test the siren, then press [OK]. Alternatively, you can
enter the area number, then press [OK].
The keypad will display the following during the siren
test.
External Audible
Testing Press any key to
abort
Press OK or MENU
When the siren test is complete, the keypad will display
the following:
Testing Complete. Press
OK to continue
Press OK or MENU
3. Press [OK] to exit.
Outputs > Output Testing >

Internal Siren Test

This menu allows you to test any internal sirens which have been
connected by your installer. The test will last for 5 seconds.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [9] + [1].
If the system has been partitioned, the keypad will
display a list of areas.
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
PRESS

2. Use the [↑] and [↓] keys to select the area that you want to
test the bell, then press [OK]. Alternatively, you can enter
the area number, then press [OK].
The keypad will display the following during the bell test.
20
MENU 4-9-0
OK or MENU
MENU 4-9-1
OK or MENU
Internal Audible Testing
Press any key to abort
Press OK or MENU
When the bell test is complete, the keypad will display
the following:
Testing Complete. Press
OK to continue
Press OK or MENU
3. Press [OK] to exit.
Outputs > Output Testing >

Strobe Test

This menu allows you to test the external strobe light.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [9] + [2].
If the system has been partitioned, the keypad will
display a list of areas.
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
PRESS

2. Use the [↑] and [↓] keys to select the area that you want to
test the strobe, then press [OK].
Alternatively, you can enter the area number, then press
[OK].
The keypad will display the following during the strobe
test.
Strobe Activated. Will
Reset On exit
Press OK or MENU
Check and verify that the strobe light is on.
3. Press [OK] to exit.
MENU 4-9-2
OK or MENU
Bosch Security Systems 09/06 BLCC110U