Pro-Form 415 S Treadmill User Manual page 7

2. Orient the Left Upright (31) as shown, and attach
it to the Base (48) with two Upright Bolts (40) and
two Upright Star Washers (39); do not tighten
the Upright Bolts yet.
3. Attach a Wheel (45) to each side of the Base
(48) with a Wheel Bolt (40), two Wheel Spacers
(44), and a Nut (47) as shown. Do not over-
tighten the Wheel Bolts; the Wheels should
turn freely.
4. Raise the Uprights (31, 36) so that the Base (48)
is flat on the floor and positioned as shown.
Cut the tie holding the Upright Wire (28) in a bun-
dle.
See the far right drawing. Wrap the wire tie in the
Right Upright (36) around the end of the Upright
Wire (28). Then, pull the other end of the wire tie
until the Wire Harness is extending from the
upper end of the Right Upright.
Make sure that the end of the Upright Wire
(28) does not fall into the Right Upright (36).
2
Latch
Holes
31
3
44
45
44
47
40
4
28
Wire Tie
31
7
48
39
44
45
44
47
48
36
28
Large
Hole
Wire
Tie
48
39
40
40