Pro-Form 415 S Treadmill User Manual page 10

10. Lower the Uprights (31, 36).
See the inset drawing. Position the Uprights (31,
36) so that the treadmill Frame (74) is centered
between the Uprights.
Firmly tighten the Frame Bolts (32) and then the
Upright Bolts (40) on each side of the treadmill.
Do not overtighten the Frame Bolts.
11. Attach the ground wire on the Upright Wire (28)
to the indicated hole in the Base (48) with a
Silver Ground Screw (27).
Press the indicated grommet into the Right
Upright (36).
Raise the Uprights (31, 36).
12. Attach the Latch Housing (30) to the Left Upright
(31) with two 3/4" Screws (2). Make sure that
the large hole in the Latch Housing is on the
side shown. Do not overtighten the Screws.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin as
shown. Insert the pin into the Latch Housing
(30), and tighten the knob back onto the pin.
13. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt
(see page 21). To protect the floor or carpet, place a mat under the treadmill.
10
74
View from Above
31
11
48
Ground
Wire
12
Knob
2
Spring
Collar
10
32
Side View
31, 36
74
Grommet
36
28
27
30
Pin
40
36
31