Introduction; Guide Organization; Table 1: D7212G Operation And Installation Guide Organization - Bosch D7212G Operation And Installation Manual

1.0

Introduction

This guide addresses the operation and installation of the D7212G Control/Communicator only and should not be used in
conjunction with the D9412G, D7412G, D9412, D9112, D9112B1, D7412, D7212 or D7212B1 Panels.
Throughout this guide, unless expressly stated, the words "panel" and "control/communicator" refer to the D7212G.
Section 2.1 9000G Series Panel Differences on page 13 provides an overview of the differences between the D9412G, D7412G,
and D7212G panels.
1.1

Guide Organization

This guide is divided into sections and appendices, summarized in Table 1.
Description
Section
1 Introduction – provides information on the structure of the guide, lists other literature related
to this control/communicator, and describes the FCC rules with which it complies.
2 Overview – provides an overview of the D7212G Control/Communicator, including operational
specifications and standard features.
3 Installation – provides installation instructions for connecting the power terminals plus the
status and battery LEDs.
4 Power Supply – provides information on the primary and secondary modules and instructions
on connecting and programming them.
5 Power Outputs – provides information on the power outputs and instructions on installing the
transformer; explains the status and battery LEDs.
6
Telephone Connections – provides information on connecting the phone line and
programming it for use.
7 On-Board Points – provides information on the on-board points and their parameters.
8 Off-Board Points – provides information on the off-board points and their parameters,
including the installation, wiring and testing of OctoPOPITs.
9 Off-Board Relays – describes the installation and wiring of the D8129 OctoRelay.
10 Arming Devices – describes the installation, wiring, programming and operation of
independent zone control modules.
11 SDI Devices – provides a description and installation instructions for various SDI device
modules.
12 Programmer and Accessory Connections – describes the Programmer Connector and the
Accessory Connector.
13 Faceplate – provides an illustration of the D7212G panel
Appendix Description
A System Wiring Diagrams – illustrations showing the terminal wiring connections for the
D7212G.
B Point Address Chart – provides ZONEX point addresses for POPITS.
© 2003 Bosch Security Systems

Table 1: D7212G Operation and Installation Guide Organization

D7212G Operation and Installation Guide
Page 9
D7212G
Introduction
4998138544C