Auxiliary Functions - Bosch GVS1000 Operation Manual

14 en | Standard Operations
–
Note: An Auxiliary command that is sent during tour operation, once a tour has been initiated,
can cause the tour to be interrupted, causing the unit to maintain all current operations until
limits are reached. If this does occur, it is possible to manually override the operation by
performing a manual movement command (for example, a pan, tilt or zoom command, calling
a preset position, or calling a preset tour function).
For example, while performing a tour operation (consisting of panning clockwise, tilting
down, and zooming in simultaneously) an auxiliary command is used while these tour
operations are active these same commands will continue until the limits are reached.
Reaching the above limits would equate to: reaching the clockwise pan limit, reaching the
down tilt limit, and reaching maximum zoom setting.
2.6

Auxiliary Functions

Auxiliary functions are specialized functions of the system. Each of the auxiliary functions can
be called by using the auxiliary on/off command or by calling a pre-programmed preset.
Aux 1: Doubler On/Off
Aux1 ON or Call preset 51: doubler on
Aux1 OFF or Call preset 61: doubler off
Default: Doubler disengaged
Increases focal length by 2x. When engaging the doubler, the amount of light transmitted
through the lens is reduced. Therefore, it is generally best practice to use this function in the
day or when abundant ambient light is present at the viewing area.
Aux 2: Wiper On/Off
Aux2 ON or Call preset 52: wiper on
Aux2 OFF or Call preset 62: wiper off
Default: wiper off
When wiper is activated, it will remain on until the deactivate command is given.
F.01U.173.867 | 2.0 | 2010.11
To program Tour 2 follow this command sequence:
– Program Preset 82(Enter programming mode)
– Call Preset 01 (Position 1 of the camera)
– Call Preset 04 (Dwell time at the 1st position)
– Call Preset 03 (Position 2 of the camera)
– Call Preset 03 (Dwell time at the 2nd position)
– Call Preset 04 (Position 3 of the camera)
– Call Preset 05 (Dwell time at the 3rd position)
– Program Preset 87(Exit programming mode)
– Call Preset 85 (To start Tour 2 operation)
Operations Manual
Global View Station 1000
Bosch Security Systems, Inc.