Replacing A Hard Drive - Bosch DVA-12T Installation Manual

Iscsi premium series raid subsystem
Hide thumbs Also See for DVA-12T:
Table of Contents

Advertisement

RAID Subsystem DVA-12T | Installation Manual
6.7.2

Replacing a Hard Drive

When a hard drives fails, it needs to be replaced. To replace a hard drive, please follow these
steps:
CAUTION!
The hard drive is fragile; please always handle with extreme care. Do not drop the hard drive;
always be slow, gentle and careful when putting down a hard drive. Only handle the hard drive
by the edges, avoid touching any components or connectors.
1.
CAUTION!
Replacing the wrong drive in an array can fatally fail a RAID configuration. You should identify
a failed drive from the RAIDWatch GUI screen, by checking the drive slot ID in the terminal
screen, by checking the LEDs on the drive tray panel, and/or use the identify/flash drive func-
tion of firmware.
2.
Fig. 6.11 Front View of an Individual Drive Tray
3.
Bosch Security Systems
Remove drives slowly: When removing a drive tray, withdraw it from the enclosure slowly.
If the drive tray is removed too quickly a drive I/O timeout might occur.
Replacement on-hand: Before removing a failed hard drive from the subsystem, make
sure you have a replacement hard drive readily available. Do not leave the drive tray slot
open for an extended period of time. If the drive tray slot is left unoccupied for an
extended period of time, the airflow within chassis will be disrupted and subsystem com-
ponents will overheat and may become permanently damaged.
Identify the drive tray that contains a faulty drive that needs to be replaced.
Open the front flap. To open the front flap, push the release button at the front of the
drive tray. (See Figure 6.11) The drive tray front flap will automatically be lifted and the
drive tray will be dislodged from the chassis.
Remove the drive tray. To remove the drive tray from the enclosure, the key-lock must be
unlocked. (See Figure 6.12) To do this, turn the key-lock on the front of the drive tray
until the groove on its face is in a horizontal orientation.
Subsystem Maintenance and Upgrading | en
F.01U.027.798 | V1 | 2006.06
41

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents