Cleaning Your Machine - Bissell DEEPCLEAN LIFT-OFF User Manual

Operations

cleaning your machine

1. Flush out machine of any remaining residual
solution.
a. Fill the formula & water tank with hand
hot (60°C/140°F MAX) tap water and turn
on your machine.
b. Recline handle and press the spray trigger
for about 15 seconds while making forward
and backward passes on carpet. Continue
without pressing the spray trigger until there
is no more water being suctioned up.
c. Turn off the machine and wrap the power
cord. Make sure the dirty tank and the
formula & water tank are emptied, rinsed,
and dried before the next use.
d. before you replace tank, clean all debris
from red filter screen.
2. Rinse nozzle assembly of any dirt and debris.
a. Remove portable spot cleaner from the
base of the machine.
b. Remove the nozzle assembly from the
machine by unscrewing 3 screws and lifting
away the upper and lower nozzle.
c. Rinse upper and lower nozzles out at the
faucet.
d. Place lower nozzle back onto the machine
by hooking the tabs into the holes on the
bottom sides of the front of the machine.
e. Place upper nozzle onto the lower nozzle
by hooking the tabs into the holes on the front
of the lower nozzle. secure with 3 screws.
3. The inside of the end caps can be wiped
out with a clean paper towel, or for a more
thorough clean, the end caps can be taken
off and rinsed clean.
4. Any loose hair or debris can be pulled from
the brush rolls and thrown away. For a more
thorough clean, follow directions on page 13
for removal of brush rolls. Your machine is now
ready to be stored.
NoTe: Store cleaner in a protected, dry area.
Since this product uses water, it must not be
stored where there is a danger of freezing.
Freezing will damage internal components
and void the guarantee.
WaRnInG
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Tip
2b. 2d.
2e.
Tip
www.bissell.com
» For best results empty,
rinse and dry both tanks
before storing.
» Let all parts dry completely
before replacing back
onto machine.
9