Mount Power Supply Box - Bosch VG5 800 SERIES Installation Manual

16 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
CAUTION!
Select a rigid mounting location to prevent excessive vibration to the AutoDome camera.
2.3

Mount Power Supply Box

Before mounting the Power Supply Box decide if you should wire the box through the holes in
the bottom or back of the box. If wiring the box through the back, move the two (2) seal plugs
to the bottom through the holes before mounting.
NOTICE! Use 3/4-inch (20-mm) NPS fittings for the holes on the bottom and back of the box.
Use 1/2-inch (15-mm) NPS fittings for the side holes.
Figure 2.1 Power Supply Wall (with optional trim skirt), Mast (Pole), and Corner Mounts
1.
2.
WARNING!
A stud diameter of 6.4 mm (1/4 inch) to 8 mm (5/16 inch) able to withstand a 120 kg (265 lb)
pull-out force is recommended. The mounting material must be able to withstand this pull out
force. For example, 19-mm (3/4-inch) minimum for plywood.
3.
4.
5.
F.01U.273.797 | 5.0 | 2012.08
Use the wall mount template supplied in the packaging box to locate the four mounting
holes for the Power Supply Box.
Drill four (4) holes for the mounting anchors. If installing outdoors, apply a weatherproof
sealant around each hole at the mounting surface.
Place the Power Supply Box into the optional Trim Skirt.
Secure the Power Supply Box to the mounting surface.
– For a Wall installation: Use four (4) corrosion-resistant, stainless steel studs (not
supplied). Then proceed to Step 5 below.
– For a Corner installation: Secure the Corner Plate to the wall corner using four (4)
studs (not included). Then proceed to Step 5 below.
– For a Mast or a pole installation: The metal straps included with the Mast mount
accommodate a pole with a diameter of 100–380 mm (4–15 in.). You must use a
banding tool (sold separately) for a mast or pole installation. Follow the instructions
provided with the banding tool to securely mount the Mast Plate to the pole.
Contact your Bosch Sales Representative to order Banding Tool P/N TC9311PM3T.
Secure the Power Supply Box to the Corner Plate or Mast Plate using the four (4) 3/8 x 1-
3/4-inch bolts and split lock washers (supplied).
Installation Manual
AutoDome 800 Series HD PTZ Camera
Bosch Security Systems, Inc.