Setting Dynamic Route Seek; Setting The Rds-Tmc Voice Guidance To Interrupt The Radio Or Cd, Etc; Selecting Tmc Reception (Only When Tmc-001P Is Connected) - Alpine NVD-T003 Owner's Manual

3
The traffic event information on the route that you
selected is displayed.
When there are more than one pieces of the traffic
event information, move the Flipper switch up or down
to select the further information you want to know.
Press the OK button or MODE knob to execute the
selection.
4
Further information is displayed.
When there are more than one piece of the further
information, move the Flipper switch up or down to
display any further information.
Tip
While receiving the TMC and displaying your vehicle's
position, press the OK button for more than two seconds to
display the traffic event information on the route that you
have set. If there is no information on the route that you
have set, all other receiving information is displayed.

Setting Dynamic Route Seek

1
In RDS-TMC Information Menu, move the Flipper
switch up or down to select "Dynamic Nav."
Press the OK button or MODE knob to execute the
selection.
2
The display changes to "Dynamic Nav." setting.
Move the Flipper switch up or down to select "On" or
"Off."
Press the OK button or MODE knob to execute the
selection.
3
When you set to ON, a message regarding an evasion
route is displayed while guiding the current route.
Move the Flipper switch up and down to select "Yes,"
then press the OK button or MODE knob to execute
the selection. The unit seeks for a route in
consideration of the traffic event given through the
RDS-TMC information and new guidance will be given.
Note
When you set to OFF, the unit performs an initial seek for a
route without consideration for any traffic event given through
the RDS-TMC.
Setting the RDS-TMC Voice Guidance
to Interrupt the Radio or CD, etc.
1
In the RDS-TMC Information menu, move the Flipper
switch up and down to select "Guide."
Press the OK button or MODE knob to execute the
selection.
2
The display changes to the "Guide" setting display. Move
the Flipper switch up or down to select "On" or "Off."
On : TMC voice guidance will activate
Off : No TMC voice guidance
3
Press the OK button or MODE knob to execute the
selection.
Selecting TMC Reception (Only when
TMC-001P is connected)
If the optional RDS-TMC receiver box TMC-001P is
connected, reception of TMC can be set for either
"Country" or "Station."
1
In RDS-TMC information Menu, move the Flipper
switch up and down to select "Set up RDS-TMC."
Press the OK button to execute the selection.
2
The display changes to "Set up RDS-TMC."
Move the Flipper switch up and down to select
"Country" or "Station."
Press the OK button or MODE knob to execute the
selection.
3
Move the Flipper switch to select the name of the
country or station you selected in step 2.
Press the OK button or MODE knob to execute the
selection.
If you select "Auto," a station will be selected and
received automatically.
Note
If you select stations or countries listed as receivable in the list
while you are in the area where these stations are not receivable,
the TMC receiving is not functioned.
23
-EN