Table of Contents
Advertisement
6
Select the speaker characteristic by touching [ ],
[ ] or [ON], [OFF] of the desired speaker setting.
1
OFF*
:
When no speaker is connected.
SMALL:
When a speaker that cannot play low frequencies
(80 Hz or less) is connected.
2
LARGE*
: When a speaker that can play low frequencies
(80 Hz or less) is connected.
1
It is not possible to set the front speakers to "OFF".
*
2
*
If the front speakers are set to "SMALL", the rear and
center speakers cannot be set to "LARGE".
• The subwoofer can be set only to ON/OFF.
• If the center speaker is turned "OFF," the center channel's audio
signals are added to the audio signals output from the front speakers.
• If you set the speaker response to "OFF," also set the speaker setting
to "OFF." (page 40)
• Perform the setup for all the speakers ("Front," "Center," "Rear"
and "Subwoofer"). If not, the sound may not be balanced.
• When center is set to "OFF", the setting is ineffective even if center
is set with this function.
• Through changing the settings on each speaker, a change in the
output of the other speakers may occur due to the setting
requirements.
• When using the PRO LOGIC II, if the rear speaker is set to
"LARGE", then there will be no output from the subwoofer.
Setting of Dolby Digital
1
Check that Defeat mode is off.
2
Touch [SETUP] on the main source screen.
The SETUP selection screen appears.
3
Touch [i-Personalize].
The i-Personalize screen will appear.
4
Touch [
] of A.PROCESSOR.
The A.PROC list screen appears.
5
Touch [
] of MULTI CH SETUP.
The MULTI CH SETUP display appears.
Set the items below as you desire.
Adjusting the acoustic image
(BI-PHANTOM)
In most installations, the center speaker must be placed directly between
the front passenger and driver. Using this function, the center channel
information is distributed to the left and right speakers. This creates an
acoustic image simulating a center speaker directly in front of each
listener. Adjusting the center width in PL II MUSIC (see "Using the Pro
Logic II Mode," page 46), makes this function ineffective.
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is canceled if the Decode mode is switched.
Touch [
] or [
] of BI-PHANTOM to adjust the level.
The level can be adjusted within the range of -5 to +5. The
higher the level, the more the position of the center speaker is
shifted to the sides.
The BI-PHANTOM function is turned off by touching [OFF].
• This adjustment is effective when the setting of the center speaker to
SMALL or LARGE in the speaker setup settings.
• This adjustment is ineffective when the speaker is set to CENTER
OFF in "Setting the Speakers" (page 40).
Mixing bass sound to the rear channel
(REAR MIX)
This function mixes the front channel audio signals to the audio signals
output from the rear speakers, improving the sound in the vehicle's rear
seat.
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is canceled if the Decode mode is switched.
Touch [
] or [
] of REAR MIX to adjust the level.
The level can adjusted in five steps: -6, -3, 0, +3 and +6. The
higher the level, the more bass is output from the rear speakers.
(The effect differs according to the software (DVD, etc.).)
The REAR MIX function is turned off by touching [OFF].
• This adjustment is ineffective when the rear speaker setup setting is
set to "OFF."
• For linear PCM signals, the voice is output from the rear speaker
regardless of the REAR FILL and REAR MIX setting.
Achieving powerful high volume sound
(LISTENING MODE)
With Dolby Digital, the dynamic range is compressed so that powerful
sound can be achieved at regular volume levels. This compression can
be canceled to achieve an energetic sound with even greater power, like
the sound in a movie theater.
This function works only in the Dolby Digital mode.
Touch [
] or [
] of LISTENING MODE to select STD or MAX.
STD: For powerful sound at regular volume levels
MAX: For powerful sound at high volumes
• Keep the volume to a level at which sounds outside the vehicle can
still be heard.
45
-EN
Advertisement
Table of Contents
