Service Manual M695
Doc Code 636 718
Replacing swingarm cable
Screw off cover ring (1) and cut off cable tie (2)
from cable duct (3).
Remove 2 screws (4) and extract plug plate (5)
complete with Lemo plug.
Open AMP plug and push contact pins out to
the rear.
Pull cable out from swingarm.
Note:
Tie a 1.5-metre long string to the cable so that it
is easier to pull in.
Assembly:
Bundle together the contact pins of the new
cable and bind them with adhesive tape.
Raise the swingarm to its highest position and
pull in the cable.
Secure cable duct (3) with a cable tie, one metre
away from the AMP plug.
Replacing modules
09/93 3691-DMF