To access a repeater which requires an odd-split frequency pair, change the
offset frequency from the default which is used by most repeaters.
1 Enter Menu mode and access Menu No. 7 (OFFSET).
2 Rotate the ENC control to select the appropriate offset frequency value.
•
The selectable range is from 0.000 MHz to 29.950 MHz, in steps of 50 kHz.
3 Press [MENU] or [PTT] to exit Menu mode.
Note: After changing the offset frequency, the new offset frequency will also be used by
Automatic Repeater Offset.
ACTIVATING THE TONE FUNCTION
To turn the Tone function on:
1 Press [TONE] to turn the Tone function On.
•
Each time you press [TONE], the selection changes as follows:
➡
Tone (
)
•
The "
" icon appears on the display when the tone function is On.
2 Press [T.SEL].
•
The current Tone frequency appears on the display and blinks.
3 Rotate the ENC control to select your desired frequency.
•
To exit the tone frequency selection, press [PTT].
4 Press any key other than [MONI], [LAMP], or [PTT] to set the selected
frequency.
Note: If you have set up a Memory channel with a tone setting, simply recall the Memory
channel instead of setting up the tone frequency every time.
32
SELECTING AN OFFSET FREQUENCY
TONE FUNCTION
➡
CTCSS (
)
DCS (
➡
)
Cross Tone ( )
➡
Off (no display).