ProForm 310 Cx Bike Manual page 9

7. The Console (7) can use four D batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before insert-
ing batteries. Otherwise, you may damage
the console displays or other electronic com-
ponents. Remove the screw and the battery
cover, and insert batteries into the battery com-
partment. Make sure to orient the batteries
as shown by the diagram inside the battery
compartment. Then, reattach the battery cover.
To purchase an optional power adapter, call
the telephone number on the cover of this
manual. To avoid damaging the console,
use only a manufacturer-supplied power
adapter. Plug one end of the power adapter
into the receptacle on the frame of the exercise
bike; plug the other end into an outlet installed in
accordance with all local codes and ordinances.
8. While another person holds the Console (7)
near the Handlebar (6), connect the wires on the
Console to the Wire Harness (89) and the Frame
Pulse Wire (91).
Insert the excess wire downward into the Upright
(4) or upward into the Console (7).
Tip: Avoid pinching the wires. Attach the
Console (7) to the Handlebar (6) with four M4 x
16mm Screws (98).
7
Screw
7
8
7
Avoid pinching
the wires
9
Battery Cover
Batteries
98
6
91
89
4