Healthrider H92 E Elliptical Manual page 16

HOW TO TURN ON THE POWER
IMPORTANT: If the elliptical has been exposed to
cold temperatures, allow it to warm to room tem-
perature before you turn on the power. If you do
not do this, you may damage the console displays
or other electrical components.
Plug in the power cord (see
HOW TO PLUG IN THE
POWER CORD on page
13). Next, locate the power
switch on the frame near
the power cord. Make sure
that the power switch is in
the reset position.
The display will then light and the console will be ready
for use.
Note: When you turn on the power for the first time,
the ramp will calibrate automatically. The ramp will
move upward and downward as it calibrates. When the
ramp stops moving, the ramp is calibrated.
IMPORTANT: If the ramp does not calibrate auto-
matically, see HOW TO CALIBRATE THE RAMP on
page 20 and manually calibrate the ramp.
HOW TO USE THE MANUAL MODE
1. Begin pedaling or press any button on the
console to turn on the console.
See HOW TO TURN ON THE POWER above.
2. Select the manual mode.
Each time you turn on the console, the main menu
will appear.
To select the manual
mode, press the
increase and decrease
buttons next to the
Enter button and high-
light START. Then,
press the Enter button.
If you have selected a workout or the iFit Training
mode, press the Menu button to return to the main
menu.
3. Change the resistance of the pedals and the
Reset
Position
4. Follow your progress with the display.
16
incline of the ramp as desired.
As you pedal, change the resistance of the pedals
by pressing one of the numbered Resistance but-
tons or by pressing the Resistance increase and
decrease buttons located on the console or on the
right upper body arm.
Note: After you press the buttons, it will take a
moment for the pedals to reach the selected resis-
tance level.
To vary the motion of the pedals, you can change
the incline of the ramp. To change the incline,
press one of the numbered Ramp buttons or press
the Ramp increase and decrease buttons located
on the console or on the left upper body arm.
Note: After you press the buttons, it will take a
moment for the ramp to reach the selected incline
level.
The console offers several display modes. The
display mode that you select will determine which
workout information is shown. Press the Display
button repeatedly to select the desired display
mode.
The display can show the following workout
information:
Calories——This display mode will show the approx-
imate number of calories you have burned.
Profile——When a workout is selected, this display
mode will show a profile of the resistance levels of
the workout.
Pulse——This display mode will show your heart
rate when you use the handgrip heart rate monitor
or the chest heart rate monitor (see step 5 on page
17).
Ramp——This display mode will show the incline
level of the ramp for a few seconds each time the
incline level changes.